|
|
|
|
| Welcome, Guest | Home | Search | Login | Register | |
| Author | Problem W/Open Transport On Performa 636 (Read 6740 times) | ||||||||||
|
limeeater
2 MB  Posts: 2 
|
on: February 10, 2009, 05:20
Hi, I have a heavily upgraded project mac (Performia 636CD-Sys 7.5.5)that I installed an Asante MCiLC 10T ethernet card in with the hope of getting this mac on the internet. As far as I can tell, I have managed to install the correct drivers for the card on the mac with the Asnate installer 5.6.1 that I downloaded- however, once I try to switch the computer from classic networking over to Open Transport it freezes during the boot just after loading the first four extensions... Any ideas? |
||||||||||
|
dpaanlka
|
1024 MB Posts: 1646
Reply #1 on: February 10, 2009, 18:28
|
Try disabling AppleTalk and TCP/IP first, then switching, then rebooting and re-enabling. Or, just do a good old fashioned extensions disabled, use Extension Manager to enable ONLY the extensions related to OpenTransport, and see what happens. Also be sure to update OpenTransport.
|
IronTooth
|
8 MB Posts: 14
Reply #2 on: February 11, 2009, 14:25
|
Quote from: "dpaanlka" Try disabling AppleTalk and TCP/IP first, then switching, then rebooting and re-enabling. A thought - If you have done all of the System 7 Today - recommended updates, you would have installed Open Transport 1.3. I had gone thru and installed all of the updates on my PB1400cs/133, and then found out that Location Manager wouldn't recognize AppleTalk and TCP/IP configurations that I had created. I did a complete reinstall of System 7.6.1 with all of the updates _except_ I only updated as far as Open Transport 1.1.2, and the problem went away. Perhaps you are having an extension conflict relating to the version of Open Transport. - Don
|
|
Pages: [1]
|
| |||
|
© 2021 System7Today.com. |
