|
|
|
|
| Welcome, Guest | Home | Search | Login | Register | |
|
Profile Info |
|
| Summary | Show Posts |
| Show Posts | |
| This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to. | |
| Messages - mrwswd | |
|
1
Software / Claris CAD software
January 31, 2016, 20:20 |
Was looking to see if anyone has Claris cad software? Either version is fine. Daniel |
|
2
New Member Welcome / Performa Still Running
August 11, 2015, 21:24 |
This site is a great resource. I regularly use a Performa 6200 (I know its the best Mac out there....) it is on 7.6.1 with 64MB ram and the original 1.2GB drive. It also has the TV/AV card in it but that has not seen any use (I actually have the IR remote) It is used to run Labview 2 and is connected to 6 HP instruments via a National Instruments SCSI-A GPIB unit. It plugs along and is on the network through a Comm Slot Ethernet Card to allow for transfer of files as needed. Thanks again for helping to maintain support for these old machines. Daniel |
| Pages: [1] | |
|
© 2021 System7Today.com. |
